TO SET TIME OF DAY:

·          Press “Clock”:   At that time the hour will start to blink.   Set the current hour with the plus (+) and minus (-) buttons.

·          Press “Enter”:   At that time the minutes will start to blink.   Set the current minutes with the plus (+) and minus (-) buttons.

·          Press “Enter”:   Only the dots between "Hours" and "Minutes" should be blinking. You now have the current time of day set.

 

TO SET FEED EVENTS:

·          Press "Feed Event":   The number in top left corner of the screen should blink (usually #1).   "0" is your test feed and is factory set for you.  Set the duration and motor speed with the plus (+) and minus (-) buttons if needed.

·          Press “Enter”:   The hour will begin to blink.   Set hour.

·          Press “Enter”:   The minutes will start to blink.   Set minutes.

·          Press “Enter”:   Bottom left side number on screen will blink, this is the duration, it sets the length of time the feeder will throw feed.   Set duration (Usually 5 seconds).

·          Press “Enter”:   The motor speed will start to blink.   Set using plus or minus buttons. This is usually set at (FS) Full Speed here at the factory. If you don't want the feeder to spread the feed out so far, you can lower this number. If it is lowered too far, the feeder will not work at its optimum level.

·          Press “Enter”:   The feed event number will start to blink again, you can at this time advance to the next number to set another feed event or

·          Press “Enter” then press “Clock”:   Everything will stop blinking and in about five seconds you will see a number in the top left corner, this should be the number of feed events that you have set. The number at the bottom left side is the TEST DURATION.

 

TO CLEAR A FEED EVENT:

·          Press “Feed Event”:   the number in the top left corner will blink. Press Test/Clear and the program is cleared and ready to set.

 

Any Feed Events that are left with a partial setting will allow the timer to go off and empty your feeder. A cleared Feed Event should only have dots and dashes on it. The only number on the screen should be the Feed Event number.